After heavy rain, there will certainly be a lot of water in the potholes on the road. Even drivers with rich experience may not be able to avoid it all. Then how can a driver drive on the road to protect his car from “torture� First: Drivers should slow down and observe themselves When the driver saw the potholes in the road, he should stop and watch the car to see which part of the car was in the water. If the water is not deep, you should keep it at a low speed and you can't step on the accelerator to speed up the speed. Otherwise, the mud splashed by too fast speed may affect the sight of the rear car; if the accumulated water is already faster than half of the tire, you should bypass it. But you can't hard drive past, otherwise this will cause the car to malfunction as much as possible. Second: If the car is passively extinguished in the stagnant water, remember that you cannot start the car again and drive it in again. Some drivers may not observe it so carefully that they will enter the stagnant office. Then the car may turn off. If the car is passively extinguished at a stagnant water, it is highly likely that the car's engine is flooded. At this time, you can't hard drive the car and you should call the trailer company to tow it away. If the engine is broken, the engine can only be sent to a repair shop for major repairs. Third: When cars pass by where there is little water, they should promptly eliminate water Excluding moisture is to exclude the moisture of the brake pads in the vehicle. If it is not discharged in time, the water on the brake pads will affect the sensitivity of the brakes and may cause serious traffic accidents. The way to remove the water is to slow down the speed and then step on the accelerator and the brakes. Note that it should be stepped on at the same time. In this way, the moisture of the brake pad can be quickly discharged. The above is what the car should do after passing through the water in the road to ensure that the parts of the car are not damaged and provide the driver with a safe driving process. This requires the driver to pay special attention to the stagnant water on the road after the rainy weather. If it is too much, then he should choose to bypass the road. The car should pay attention to the usual maintenance, if this small problem is not the case, it is sure that the car will be a big problem.
AC16, HC16 are the axle models in HOWO Truck . Howo 16T Axle is standard axle for HOWO Tractor Truck. Howo Hub-Reduction Axle is used for HOWO dumper and Mixer truck. HC16 adopts advanced design and fine manufacturing technology, so the loading capacity and adaptability are enhanced greatly; Axle housing is with high strengthen by taking advanced three pieces integral casting technology and big section design; Leaf spring seat, brake bottom plate flange and rear cover are cast into one piece with axle housing, making the stress distribution more scientifically takes strengthening design on differential assembly and wheel reduction housing; Higher rigidness and strengthens make higher loading capacity and reliability. Axle Ratios Options: Ratios of 3.93, 4.42, 4.80, 5.73, 6.72 and 9.49 are optional; ABS and clearance auto adjustment arm are optional. Applicable Areas: It is applicable to the bad & severe road conditions with big impaction; it is the best choice for heavy construction vehicles.
Howo Axle Parts,Howo 16T Axle,Howo Steyr 16 Ton Axle,Howo Hub-Reduction Axle Top Lead International Trading Co., Ltd , https://www.topleadchina.com
