Fake and shoddy auto parts can cause urban environmental pollution


In recent years, traffic accidents involving directors of fake and shoddy auto parts have appeared. A taxi driver in Hengyang City has complained that he has encountered this situation twice, once because he bought an old bearing and the wheel suddenly flies while driving. Going out, once because the brake oil pipe leaked the oil and caused the brake to fail. The car crashed into a tree and stopped. Unfortunately, it was fortunate that it was not hurt twice. However, he learned the lesson from now on, no longer to buy accessories in the small accessories store, nor to repair the car in the small repair shop. The development of modern industrial civilization has made the global awareness of environmental protection stronger and stronger. The automobile industry is facing a big problem of reducing environmental pollution. The traditional automobile industry is facing a green revolution. But fake and shoddy auto parts run counter to this, because like air filters,
The use of fake and shoddy auto parts such as oil filters and gasoline filters in the Yellow Sea accessories has greatly increased the noise and exhaust of automobiles. It is okay to say that counterfeit and shoddy auto parts are the black sheep that cause urban environmental pollution. Some brand-name companies with a little technical strength are targeting key parts that import auto parts or are more profitable.
The energy issue is a worldwide problem, and the voice of the energy crisis has been heard in recent years. Automobiles are the "big households" that consume energy. They are the first to bear the brunt of energy conservation. They are the focus of research and strict control. They not only have indicators on the fuel consumption rate of the engine, but also require energy-saving devices as much as possible. Counterfeit and inferior auto parts simply ignore this point, which greatly increases the fuel consumption rate of the car, not only wastes a lot of energy, but also causes users to suffer unnecessary economic losses.

The SPR Sump Slurry Pump is a vertical, centrifugal and Single Casing Pump. Which design with elastomer covered components makes it ideal for corrosive, non-edge angle and high density slurries. It is available in a wide range of popular sizes to suit these applications: minerals processing, coal preparation, effluent handling, chemical processing, sand and gravel and general tank, pit or hole-in-ground slurry applications. With no any shaft seal or sealing water, the pump can also be operated normally even when there is insufficient slurry getting to the suction side.

Product Feature

1.Available in various standard lengths to suit common sump depths, a suction extension pipe can be fitted to the bottom inlet to extend the depth of the pump.

2.The Impeller is double suction half-open structure.

3.The pump inlet has three type construction: standard type with strainer, suction pipe with strainer, with agitator.

4.Two driving modes of the pump : Direct drive, V-belt drive .

SPR Sump Slurry Pump

SPR Sump Slurry Pump,Mud Sump Slurry Pump,Sump Slurry Rubber Pump,Long Shaft Sump Slurry Pump,SPR Sump Slurry Pump

Shijiazhuang Soarho Machinary Co.,Ltd , http://www.xhslurrypump.com