Oil Sump Pump,Centrifugal Slurry Pump,Battle Max Slurry Pump,Peripheral Water Pump Hebei Yongquan Pump Industry Co., Ltd. , http://www.cnsolarpump.com
The installation of the pipe ring stiffness tester is similar to that of the electronic universal tester. However, due to the special nature of the test space, several requirements must be considered before installation.
1. The installation position should be solid and smooth, without foundation.
2. Take care to protect the paint on the surface of the machine and avoid collision with the steel plate cover.
3. The space height is not less than 4000mm, the main reason is that the test space is 3 meters for the testing machine itself, plus the workbench and upper beam and the space for easy installation test should not be less than 5 meters. In order to avoid the collision caused by the ring stiffness tester during the installation due to the low space, the tester cannot work normally.
4. Hoisting of the tester 1) The tester's host cover plate cannot be loaded. Therefore, do not tie the cable directly to the cover plate. Usually, the lifting device is a lifting device provided by the upper beam or the machine.
2) Please lift lightly when lifting.
3) When erecting the main unit, remove the eyebolts on the foot plate and pay attention to the change of the center of gravity of the main unit to prevent overturning.
Then start installing now:
1. The installation of a variety of random accessories, this mainly includes the installation of the host computer, display, printer, this part of the installation of the accessories is very simple, the user can refer to the ring stiffness testing machine factory manual, but also according to the family of such equipment The installation method is to be installed.
2. Cable installation:
Including 1. load sensor signal output interface;
2. The computer host corresponding interface is connected;
3. The printer and computer cable;
4. The connection of the manual control box is connected.
In addition to the third user, even if he knows that the interface is that interface, the user can still install it, because the correct installation can connect two parts closely, and if it is wrong, it cannot be installed in the corresponding slot. The installation of item 3 is mainly based on the printer's instructions.
3. Test machine adjustment level: When everything is ready to be installed, the last step is left, that is, the horizontal adjustment of the test machine: when adjusting, first place the backing plate under the bottom plate, and then place the 0.02mm/m level instrument. On the tester's work surface. There are four horizontal adjustment screws, one of which is rotated downwards so that the bottom plate is about 2mm away from the pad, and the depth of rotation of the other three horizontal adjustment screws is adjusted based on this height so that the worktable is in two mutually perpendicular directions. Level is within 0.2/1000.
After some of the above steps, the ring stiffness tester was successfully installed.
Pipe Ring Stiffness Universal Testing Machine Installation Procedure Precautions
Ring stiffness testing machine is widely used in the determination of the ring stiffness of thermoplastic plastic pipe and glass steel pipe with annular cross-section, meet the requirements of PE double-stranded bellows, coiled pipe and various pipe standards, can complete the pipe ring stiffness, ring flexibility, Flat, weld tensile tests.