Focus on landscaping, starting with understanding landscaping spray trucks

Landscaping and spraying vehicles were developed under the theme of strengthening environmental protection and increasing urban afforestation in the industrial era. They have adopted a variety of new technologies and new energy sources, mainly used for garden seedling protection, urban afforestation, and factory dust removal. Fire-fighting, flooding, and other aspects of washing, due to its practical, environmental protection and other features are more favored.

1

The landscaping and spraying vehicle integrates the two functions of greening and spraying insecticide, so it can not only solve the need for greening and watering, purify the air, but also satisfy the needs of users for spraying drugs, eliminating pests, and protecting crops. It is a dual-purpose car. So how can a landscaping sprayer be used and maintained properly?

First of all, to mention how to use it correctly, besides ensuring that the technical performance of the sprayer in use meets the relevant technical requirements, the driver must also operate correctly in accordance with the instruction manual. He must be cautious in driving and must be on a safe driving mentality. Do not let irresponsibility be wasted. Frivolous driver operation, threatening personal and property safety. Secondly, during the operation and operation of the driver, the driver must strictly abide by the operating procedures and must not violate the rules. Any danger or malfunction found during the operation should be immediately checked for failure, to find the fault, and it is forbidden to continue using it until the repair is completed. Finally, in the event of an engine burnout, breakage of the frame boom, and failure of the brake seriously endangering or leading to personal injury or death, if the critical components are seriously damaged, the work must be stopped immediately, the site checked, and the leaders and relevant personnel must be dealt with afterwards.

When it comes to proper maintenance, you first need to read the instructions carefully to understand their basic requirements. Secondly, there are some details that need attention. During the maintenance, it is forbidden to spray the pump and the sprinkling pump without water for a long time. If you want to idle for a long time, be sure to inject a small amount of water into the pump. In the cold winter, especially in the north, the liquid remaining in the machine should be drained after each use to avoid freezing the machine parts. Finally, with regard to the storage of machinery, it should be noted that fuel and water are to be drained and placed in a place with ventilation, moisture, sprinkler and fire-fighting facilities.


Crankshaft Position Sensor

The crankshaft position Sensor is usually installed inside distributor, is one of the most important sensor in the ignition system. Normally crankshaft position sensors have Hall- type, Magnetic-electric type and Photoelectric type. Its functions are as following: first, it can detect engine speed, therefore, it also known as the rotational Speed Sensor. Second, it can detect the position of top dead center of piston, so also know as TDC sensor.

Sometimes, the sensor may become burnt or worn out. The most likely causes of crankshaft position sensor failure are exposure to extreme heat. Many modern crankshaft sensors are closed units and therefore will not be damaged by water or other fluids. When it goes bad, it stops transmitting the signal which contains the vital data for the ignition and other parts in the system.


Crankshaft Position Sensor,Engine Crankshaft Position Sensor,Electrical Crankshaft Position Sensor,Hyundai Crankshaft Position Sensor

NINGBO DGOFEN AUTO TRADE CO., LTD , https://www.dgofen.com